1) CAMEC water filler - hinged lid - One-Key Compatible

The CAMEC hinged lid water filler come One-Key ready where the barrels are a direct replacement for the barrels supplied with the filler. These water fillers (see 2 below) were released in 2011 as a direct replacement for the earlier VECAM and CAMEC (see 1 below) lockable water fillers with the removable cap.

To replace the barrel included with filler (2 above) follow these easy steps.

Above:
(1) While unlocked, insert RED key into the original pre-installed BLACK key barrel. Remove the original barrel by pulling the RED key.
(2) Insert the BLUE key into the new barrel then place the new barrel into the water filler.

Your Water filler will now open with any of the supplied Blue Keys.
To remove RED key for reuse, depress the outer circlip while pulling key.

2) CAMEC T-handles, 2 sizes. One-Key Compatible

The CAMEC T-handles have been used on thousands of Caravan boots over the years. While your existing handle produced prior to 2011 is not compatible with the One-Key system, CAMEC make two T-handles that will accommodate the One-Key barrels.

The compatible handles, part 039953 and 039954 come without any barrel and will accept the One-Key barrels.

Installation is easy.

(1) T-handle as supplied
(2) Insert BLUE key into One-Key barrel, then place barrel into T-handle

RED Key is not required unless you need to remove the barrel.

3) Thetford toilet and access doors. Lock barrel adapter

The very popular Thetford Toilets, C2, C4, C200, C400 and C250 all use the Thetford access door, plus there are many larger Thetford access doors that use the same lock. These locks can have the inner barrel housing changed to this part (there are 2 in a kit) to accept the CAMEC One-Key lock barrels.

Installation will take about 5-10mins and care should be taken to not drop parts when opening the rear of the lock. It is recommended to lay the door flat for this procedure. Full instructions are included in the pack, but briefly:

(1) Remove two philips head screws and cover from behind lock(s). Replace housing as per the instructions in the pack. Discard old housing and barrel. Replace rear cover.
(2) Insert BLUE key into One-Key barrel, then place barrel into front of door.

RED Key is not required unless you need to remove the barrel.

4) Access door lock housing. One-Key compatible

A number of small access doors use the rotating mini door lock shown below. The sliding tounge style is used on some access doors also. The identical procedure is used.

(1) The housing (both styles) come without any barrel or keys. These are a separate part.
(2) Insert BLUE key into One-Key barrel, then place barrel into front of door.

RED Key is not required unless you need to remove the barrel.

5) Camec 3 point door lock. Outside handle replacement

All CAMEC doors made before 2012 had the Original CAMEC 3 point lock which did NOT have a coloured logo. These require replacement of the outer door handle with the One-Key outer door handle, which is identified by the addition of an Aqua/Grey logo as shown below.

Most new locks purchased since 2012 should include the CAMEC logo and will be compatible with the One-Key lock barrels.

Left image shows ORIGINAL outer lock housing that needs to be replaced
Right image shows One-Key Compatible housing and has Aqua/Grey Logo

To install new One-Key barrel
(1) UNLOCK existing lock with your existing key. Then Insert RED key into the original pre-installed BLACK key barrel.
(2) Remove the original barrel by pulling the RED key.
(3) Insert BLUE key into One-Key barrel, then place barrel into front of door.

To remove RED key for reuse, depress the outer circlip while pulling key.